| RM Series
RM15AUD/RM20AUD/MAUD15/MAUD20 Rackmount and Modular Model Specifications |
|
Made in the
USA
|
- 8 grounded 3-wire #14/#12* SJT line cord
- Magnetic shielding steel cabinet: Black
- Self-test circuit with visual indicator
- Weight: 8 lbs./10 lb.*
- Dimensions: 1.75H x 19W/17.25W* x 4.7/8.2D*
|
|
Load
Ratings:
|
15/20A* @ 120 volts, single phase, 50-60 Hz; full load regulation 1%.
|
|
Receptacle Isolation:
|
Low pass filter isolation assures >40db load to load isolation for EFT bursts.
|
|
Limiters:
|
Series surge reactor current limiter; cascaded, auto-tracking dual polarity voltage limiters; dual pulse inverters. Parameters optimized for switch-mode power supply protection.
|
|
Clamping
Voltage Onset:
|
172 volts nominal; 2 volts above peak line voltage (auto-tracking).
|
|
EMI/RFI
Filter response:
|
(bi-directional, wave tracking): With 50 ohm Rg load: 3db@5kHz; 26dB@100kHz; 38dB@300kHz.
|
|
Let-Through
Slew Rate:
|
5,000 volt/s disturbance reduced to 28v/s within AC power wave envelope, and less than 10v/s outside the power wave envelope.
|
|
Snubber:
|
Instant reacting snubber for very fast-rising surges generated within the building.
|
Maximum
Applied Surge Pulse Joule Rating:
|
Unlimited rating (due to surge current limiting) (8x20s).
|
|
Maximum
Applied Surge Pulse Voltage:
|
6,000 volts (1.2 x 50s) (Industry Standard rating).
|
|
Maximum
Applied Surge Pulse Current:
|
>100,000 amperes (unlimited due to current limiting) (8 x 20s).
|
|
Endurance,
C62.41-1991 (formerly IEEE 587) Category B3 (C1) pulses:
|
2kv>100,000; 4kv>10,000; 6kv>1,000 (Submitted for NRTL verification). |
